Bandit 240 PB Manuel d'utilisateur télécharger pdf (Page 7)

Bandit 240 PB Installation and User Guide

3. Open the rear cover on Bandit.

4. Locate the 3-way terminal block for 110 VAC power.

5. Connect power leads as follows: Red to N, black to L, and ground to ground.

6. Route power cable through strain relief.

7. Reapply power to electrical line.

8. With a volt meter, test power at N and L terminals. Verify power is 110 VAC.

9. Replace the real jumper.

Connecting Accessories

You can install accessories to Bandit 240 PB that require 12 VDC power. Examples of

accessories include the Jumbo LED or an external siren.

1. Mount the accessory.

2. Connect the red wire to the +12V power supply, and the white wire to Grdout (See

Figure 1).

3. If required, connect the blue and black wires to the Ta and Tb sabotage loop.

LEDs

The following table lists the LEDs on Bandit’s front cover and their corresponding

indications.

LED Indication

Solid green Bandit is operational.OK

Blinking green Bandit is warming up; up to 50 minutes are

required for warm up after cold start.

Guard Solid red Bandit in guard mode.

Solid red Bandit in alarm mode.Alarm

Blinking red Bandit in panic mode.

Slow blinking red Internal failure detected.Failure

Fast blinking red

Technical adjustment required. Possible

causes include control box is switched on,

wrong type of HY-3 pack installed, real

jumper not plugged in (see Figure 1).

HY-3 Blinking red

Less than 15 seconds of fog ejection time

remaining in canister. Replace or refill

canister.

1 2 3 4 5 6 7 8 9 10

Pas de commentaire

Bandit 240 PB Manuel d'utilisateur Page 7