Bandit 240 PB Manuel d'installation télécharger pdf (Page 9)

p. 8 - Connection to main power supply

ELECTRICAL CONNECTION

The BANDIT 240PB is equipped with simple and yet versatile interface. This version is only

programmable through PC or laptop using the communication link.

This unit is intended to be connected to an existing alarm system or be installed as a stand-alone

unit.

The build-in electronic system takes care of controlling and securing:

- the fog generator (3 x temperature + frequency control of valve).

- tamper switch of the rear cover, HY-3 pack hatch and optional connected "Control Box".

- control of front- and PCB LED, and internal siren.

- read out of inputs and jumper adjustments.

- control of tamper-, technical- and programmable outputs.

- control of internal battery, glass fuses and internal fan.

- digital and analogue communication with the HY-3 pack.

- serial communication with PC/laptop (com port)

The complete electrical system is accessible by removing the rear cover of BANDIT (unscrewing

4 x M4 cross head screw). The rear cover is tamper secured, so be sure that the unit is not in

guard mode and that the control room (optional) is warned.

Connection on the main power supply: on the left, beneath the PCB, you’ll find a

3 way terminal block with integrated main fuse. The PCB is marked with “230 VAC supply”.

Connect the left connector strip (N) to the mains neutral (blue or white wire), the middle one to

the green-yellow ground wire and the right connector (L) to the mains phase (black wire).

Switching phase and neutral has no effect to the function of BANDIT .

The unit is secured for mains failures and can be practically seen as an Ohmic power load.

Connect the power cable through the strain relief connector (~0.5 In. beneath the left entrance in

the metal back frame).

Supply

230 VAC

Power supply

12 V

500 mA

Power supply glass fuse (5 x 20 mm)

F1 = 4 AT slow

- For complete PCB (printed circuit board) layout with description of connector strips, see page 9.

- For detailed description of

- For properties of the in and outputs, see page 10 through 31.

LED functions, see page 32 through 34.

- Preferably use a separate fuse, directly coming

from the main power supply or connect to

existing power circuit of installed controlling alarm

system (BANDIT has a peak current consumption

of 3.5 Amps. for each unit).

- For easy installing, use flexible connection wires

3 x 1.5 mm² with end splices.

BANDIT 240 PB v.206

F1 4AT

1 2 3 4 5 6 7 8 9 10 11 12 13 14 ... 46 47

Commentaires sur ces manuels

Pas de commentaire

Bandit 240 PB Manuel d'installation Page 9

Commentaires sur ces manuels

Produits connexes et manuels pour Machine à brouillard Bandit 240 PB